Infotainment Amundsen
Infotainment overview
A
Touchscreen
All menus
Favourite menus
Increase the volume
Decrease the volume
Condition-based:
▶
Infotainment switched o
▶
Tap: Turn on Infotainment
▶
Infotainment switched on
▶
Tap: Switch sound o/on
▶
Hold: Switch o Infotainment
Radio menu
Media menu
Phone menu
Navigation menu
Information about vehicle settings
System
Restriction
For safety reasons, operation of some Infotainment
functions while driving is not possible or is restricted.
The Infotainment system indicates this by means of
a message in the screen.
Basic settings
Setting basic functions
The following Infotainment functions are set in the
menu.
▶
Time and date.
▶
Language.
▶
Units.
▶
Restore factory settings.
Sound settings
The Infotainment sound is set in the menu .
The following menu items can be set.
▶
Setting the equalizer.
▶
Adjusting the volume ratio.
▶
Volume adjustment of individual Infotainment
functions.
Some are adjustable, for example the following
menu items.
▶
Volume adjustment of voice commands.
▶
Setting the maximum volume when Infotainment
is turned on.
▶
Speed-dependent volume setting.
▶
Setting the Infotainment to mute with the park-
ing aid switched on.
Depending on the equipment, the following ad-
vanced sound settings can be set.
▶
Setting space optimisation.
▶
Setting the audio profiles according to genre.
▶
Adjusting the subwoofer volume.
Configuration wizard
The configuration wizard helps to set certain Info-
tainment functions.
The configuration wizard is automatically displayed if
there are at least two non-selected menu items after
turning on the Infotainment.
›
To switch o the automatic display, tap on
Don't
show again
when the configuration wizard is displayed.
›
For manual display, tap on
Configuration wiz-
ard
.
Setting the HOME menu
›
To display another page of the HOME menu, press
the screen with two fingers and drag it to the left
or right.
To add the preferred menu, proceed as follows.
›
Tap on an empty functional surface.
Or:
›
Press and hold an occupied functional surface and
then tap on an empty functional area.
›
Select a menu with the desired dimension of the
functional surface.
›
Tap on
to exit edit mode.
To remove the preferred menu, proceed as follows.
›
Press an occupied functional surface.
›
Tap on
.
›
Tap on to exit edit mode.
91
Infotainment Amundsen › Infotainment overview
To Next Page
Loading...
Need help?
General
