›
Change the bulb in the
socket.
›
Insert the socket with
the new bulb into the
light so that the guide
lugs on the socket are
aligned with the corre-
sponding openings in
the light.
›
Turn the socket clock-
wise to secure.
›
Insert the connector into the light until it clicks into
place.
›
Insert the pins
A
of the light into the openings
B
in the body.
NOTICE
Risk of damage to the electrical system!
▶
Make sure that the cables between the light and
the body are not pinched when the light is inserted.
›
Screw the light into place.
›
Fit the cover of the light, ensuring it clicks into
place.
Reversing lights
›
Open the boot lid.
›
Release and remove
the cover cap in the
boot lid.
›
Turn and remove the
socket with the bulb.
›
Change the bulb in the
socket.
›
Insert the socket with
the new bulb into the
light so that the guide
lugs on the socket are
aligned with the corre-
sponding openings in
the light.
›
Turn the socket clock-
wise
to secure.
›
Insert the cover cap until it clicks into place.
Interior lighting
Operation
Operation of the lighting
Switching on
Switching o
Reading lights
Automatically switch on and switch o
Switching on automatically
The light switches on when one of the following
events occurs.
▶
The vehicle is unlocked.
▶
One of the doors is opened.
▶
The ignition key is removed (vehicle without start-
er button).
▶
The ignition is switched o (vehicle with starter
button).
Automatic switch o
The light switches o when one of the following
events occurs.
▶
The vehicle is locked.
▶
The ignition is switched on.
▶
About 30 seconds after all the doors have been
closed.
If a door remains open and the ignition is switch-
ed o, the lights will turn o automatically after 10
minutes.
47
Lighting, windscreen wipers and washers › Interior lighting
To Next Page
Loading...
Need help?
General
