User Manual 71
DOL 534 • DOL 539
Setting of a period of time when disinfecting takes place.
Setting of the temperature it needs to be in the house during disinfection.
Connection and disconnection of the function Preheating.
Setting of temperature for preheating at batch start.
Preheating start
temperature
Setting of temperature for preheating at batch stop.
When batch status is Empty house, the controller will disconnect all automatic settings and run
according to the settings in the Empty house in-between function.
This section is relevant only to houses with high-pressure cooling systems
or soaking systems.
Soaking will run according to a soaking function which will soak
the house with water to loosen dust and dirt. This will not only
reduce the amount of dust during the subsequent cleaning but also
make cleaning easier.
In soaking mode, stop ventilation to maintain the humidity in the house. Set the soaking system to run at
intervals (cycle time) for a number of minutes (ON-time) during the total period (soaking time) which the
soaking process is to last.
4.5.2 Washing
While washing the house manually, ventilation must run again to
start changing the air in the house.
Drying is a combination of ventilation and heating. The more heat
you supply to the house, the quicker it dries.
To Next Page
Loading...
