Time-Lapse Parameter Details
Following is a complete list of the parameters you can set. Note that because
several of the parameters are interrelated some may be unavailable at
certain mes. For instance, when Frame Rate and Video Length are set you
cannot manually choose the number of Photos as it is calculated for you
based on the other two parameters. However, if you deselect Video Length
and set Photos directly, the app will calculate a new value for Video Length.
Exposure (Sec): Fixed at 0.5 seconds for Regular-Exposure Time-Lapse.
For Long-Exposure Time-Lapse set this value to suit your exposure
requirements. Be sure to set your camera shuer to BULB mode.
Video Time Span (Hr): Set this parameter to the total Video Time Span
me for your video. For example, if you want your video to cover a span of
three hours, set Video Time Span to 3. Note that Video Time Span does not
refer to the the length of your video, it refers to the me span over which
it is created. You set the desired length of your video in the Video Length
parameter.
Video Length (Sec): Set Video Length equal to the desired length of your
video in seconds. For a one-minute long video, set Video Length to 60.
Frame Rate (fps): Select NTSC (30 fps) or PAL (25 fps) according to the video
standards for your locaon. You can further adjust the playback speed of
your video in your video eding soware.
Photos: This parameter is automacally set by seng Video Length and
Frame Rate using the formula: Photos = Video Length x Frame Rate
Frame Period (Sec): You can set the Frame Period to select a desired
interval between photos taken rather than have it calculated for you
based on other parameters. Note that if you set Photo Interval and
Video Length the app will re-calculate Video Time Span. Anyme you
are changing a parameter it is a good idea to check its eects on the
other ones.
13
To Next Page
Loading...
Need help?
General
