Skyjack SJ-7027 - Page 147

SECTION 6, Page 59
SJ-600 Series Engine Powered 112715
June 2001
Index
No.
Skyjack
Part No.
Description
Units
per
Assy.
1 (Ref.) SHAFT ASSEMBLY, Front drive 1
(For Components, Refer to Figure 6-23 or 6-24) -
2 (Ref.) AXLE, Front 1
(For Components, Refer to Figure 6-22) -
3 109775 BRACKET, Steering arm 1
4 300689 • CLAMP, 3” U-Bolt 2
117417 • CLIP, Locking (Serial #’s below 31390) 4
117430 • BOLT, Hex-hd 3/8-16 x 1-1/4” (Serial #’s below 31390) 4
5 103999 WASHER, Lock 3/8” 8
6 103315 NUT, Wheel 16
7 300690 TRIM, 1/2” 5”
8 100252 NUT, Jam 3/4-10 1
9 104002 WASHER, Lock 3/4” 2
10 102028 SPACER, Steering Clevis 4
11 (Ref.) CYLINDER ASSEMBLY, Steer 1
(For Components, Refer to Figure 6-19) -
12 103893 BOLT, Hex-hd 3/4-10 x 3-1/2” lg Grade 8 1
13 113489 BOLT, Hex-hd 3/4-10 x 3-1/4” lg Grade 8 1
14 114740 BOLT, Hex-hd 1/2-20 x 1-3/4” lg. 4
15 102030 ARM, Steering 1
16 300792 PIN, Cotter 3/32 x 1-1/4” lg. 1
17 120191 NUT, Tie Rod Castle Hex 1
18 120845 WELDMENT, Steering arm Support (Must use Castle Nut #120191) 1
.....Both part numbers 120845 & 120191 MUST be ordered for
Machines with Serial #’s 32004 & Below
19 103264 WASHER, Bronze 2” O.D. x 1” I.D. 1
20 109598 NUT, Hex jam 1/2-20 1
21 114679 BOLT, Hex-hd 1/2-20 x 2-1/4” lg. 1
22 126361 BOLT, Hex-hd 1/2-13 x 1.75” grade 8 8
23 126286 WASHER, Lock 1/2” 8
24 123856 NUT, Hex 1/2-13 8
25 103473 BOLT, Hex-hd 3/8-16 x 1” lg. 4
26 705240 NUT, Hex head 3/4 - 10 1
FIGURE 6-21. FRONT AXLE HARDWARE ASSEMBLY (4WD)