SECTION 5, Page 2
SJ-600 Series Engine Powered 112715
June 2001
OPERATOR’S RESPONSIBILITY FOR
MAINTENANCE
Death or injury can result if the work platform is not kept
in good working order. Inspection and maintenance
should be performed by competent personnel who are
familiar with mechanical procedures.
The operator should be assured that the work platform
has been properly maintained before using it. Included
in this section is information on lubrication and
inspection points that require maintenance.
Even if the operator is not responsible for the
maintenance of this work platform, the operator should
perform the daily inspections found in Table 2-4.
Maintenance and Inspection Schedule.
IMPORTANT NOTE
Replace all worn or damaged parts or labels
discovered during this inspection. Any problems or
malfunctions that may affect the safe operation of this
work platform MUST be repaired immediately.
DANGER
CRUSHING HAZARD
DO NOT reach through scissors assembly without the
safety bar properly positioned. Failure to avoid this
hazard will result in death or serious injury!
MAINTENANCE AND INSPECTION
SCHEDULE
The actual operating environment of the work platform
governs the use of the maintenance schedule. The
inspection points covered in Table 2-4. Maintenance
and Inspection Schedule indicates the areas of the
work platform to be checked and the intervals at which
they should be checked.
OWNER’S ANNUAL INSPECTION
RECORD
It is the responsibility of the owner to arrange daily,
weekly, monthly and annual inspections of the work
platform. Table 2-1. Owner’s Annual Inspection Record
in section 2 is to be used for recording the date of
inspection, owner’s name and the person responsible
for the inspection of this work platform.
GENERAL MAINTENANCE HINTS
• Before attempting any repair work, disconnect
battery ground negative (-) lead.
• Properly position safety bar if the scissors
assembly is raised.
• Preventive maintenance is the easiest and least
expensive type of maintenance.
To Next Page
Loading...
Need help?
General
