Skyjack SJ68RT Series User Manual

67
SJ6826 RT, SJ6832 RT
221587ABA
Use the platform control console from the ground Section 6 – Additional Procedures
CAUTION
Make sure the control console cable does not
become entangled with the MEWP or objects that
surround the MEWP. If you do not obey, there is a
risk of MEWP damage.
1. Before you operate the MEWP, do a full worksite
inspection to identify possible hazards in your
work area. Refer to section 2.4.
2. Cordon-off the pathway you plan to travel.
WARNING
Crush hazard. Make sure that there are no
personnel in the path you will travel. Tell personnel
around the path before you move the MEWP. Use
a second person to monitor the movement of
the MEWP. Make sure that person stays at a safe
distance. If you do not obey, there is a risk of death
or serious injury.
3. Stay behind or to the side of the MEWP.
4. Connect the platform control console cable
to the electrical connector in the engine
compartment of the MEWP.
5. Move the inclined-drive/level-drive switch to
the inclined-drive position.
6. Use as low a speed as practical to drive the
MEWP forward to the necessary location.
7. Push the emergency-stop button when the
MEWP is at the necessary location.
8. Turn the main power disconnect switch to the
off position.
WARNING
Fall Hazard. Use the three points of contact
principle when you use the MEWP ladder to enter
or exit the platform. If you do not obey, there is a
risk of death or serious injury.
9. Use the MEWP ladder to enter the platform.
CAUTION
Make sure each lock-pin is correctly installed with
the detent ball of each lock-pin fully through the
hole.
10. Install the platform control console onto the
mounting bracket. Install the lock-pin in the
mounting bracket.
11. Install the control cable into the railing clamp
and install the lock-pin.
WARNING
Fall Hazard. Use the three points of contact
principle when you use the MEWP ladder to enter
or exit the platform. If you do not obey, there is a
risk of death or serious injury.
12. Use the MEWP ladder to exit the platform.
13. Connect the platform control console cable to
the electrical connector below the platform.

Skyjack SJ68RT Series Specifications

General

Brand	Skyjack
Model	SJ68RT Series
Category	Scissor Lifts
Language	English