Skyjack SJ68RT Series User Manual

51
SJ6826 RT, SJ6832 RT
221587ABA
Function Tests Section 4 – Inspections Before Operation
4.3-18 Do a test of the auto-level (optional
equipment)
Refer to Section 5.9 for the auto-level operation.
NOTE
Make sure that you:
▪
Park the MEWP on a firm, level surface. Remove
all obstructions.
▪
Fully lower the platform.
▪
Fully retract the outriggers.
WARNING
If the outrigger interlocks fail to operate correctly,
lock and tag the MEWP. Remove the MEWP for
servicing. Only a qualified service technician must
repair the MEWP. If you do not obey, there is a risk
of death or serious injury.
1. Use the MEWP ladder to enter the platform.
2. Start the engine.
3. Move the lift/off/drive switch
4
to the lift
position.
4. Move and hold the auto-level enable switch
12
in the enable position.
5. Move and hold the auto level switch
11
in the
extend position to extend the outriggers until
all four outriggers are on the ground and the
platform is level.
WARNING
Look for overhead obstructions or other possible
hazards around the MEWP when you raise the
platform. Do not lower the platform unless the area
below is clear of personnel and obstructions. If
you do not obey, there is a risk of death or serious
injury.
6. Raise the platform by approximately 0.3 m (1 ft).
▪
Result: The platform raises.
7. Fully lower the platform.
▪
Result: The platform fully lowers.
8. Move and hold the auto-level enable switch
12
in the enable position.
9. Move and hold the auto level switch
11
in the
retract position to fully retract all four outriggers.
▪
Result: All four outriggers fully retract.
12
11
13
10
9
8
6
5
4
3
1
7
2

Skyjack SJ68RT Series Specifications

General

Brand	Skyjack
Model	SJ68RT Series
Category	Scissor Lifts
Language	English