75
SJ6826 RT, SJ6832 RT
221587ABA
Refuel Section 6 – Additional Procedures
6.9-3 Remove the propane cylinder
1. Stop the engine.
2. Push the emergency-stop button on the base
control console.
3. Turn the propane cylinder valve clockwise to
stop the fuel supply to the engine.
4. Pull the emergency-stop button. Start the
engine and let it stop by itself.
5. Move the fuel switch to the liquid propane gas
position.
6. Start the engine again to make sure the fuel lines
are empty.
7. Push the emergency-stop button.
8. Turn the propane tank hose fitting
counterclockwise to detach the coupling.
Disconnect the hose from the empty propane
cylinder.
9. Pull on the metal clips to loosen the two propane
cylinder straps. Disconnect the straps from the
hooks.
10. Remove the empty propane cylinder.
6.9-4 Install the propane cylinder
1. Push the emergency-stop button on the base
control console.
2. Put the propane cylinder on the propane
mounting bracket. Make sure the metal peg
goes through the hole on the propane cylinder
rim.
3. Reconnect the propane cylinder straps to the
hooks and fasten them tightly.
4. Attach the hose to the new propane cylinder.
Turn the fitting clockwise to tighten it.
5. Apply mild soapy water to the propane hose
connection.
6. Open the valve one quarter-turn
counterclockwise. Do an inspection for gas
leaks.
7. If there are no gas leaks, fully open the propane
cylinder valve.
8. Wipe off the soapy water after the inspection is
complete.
To Next Page
Loading...
Need help?
General
