102
SJ6826 RT, SJ6832 RT
221587ABA
Section 8 – Labels Lift cylinders
Description Label Pictorial
1
Orifice installed
Orifice installation warning
TM
2
Emergency-lowering procedure
Refer to the operation manual.
1. Turn Main power disconnect switch to off position.
2. To open the lift cylinder holding valves located at the bottom of
each cylinder:
if higher reach required, use emergency-lowering rod located
on the top of the base to:
a. push
b. turn knurled knob counterclockwise.
3. To lower the platform, pull out emergency-lowering valve
located on the outside of the hydraulic tray.
8.10 Lift cylinders
2
1
To Next Page
Loading...
Need help?
General
