SKYJACK, Page 17
April 2006
Section 2 - OperationComponent Identification
SJ800 - E Series
Battery Powered
2.2-4. Operator’s Control Box
This metal control station is mounted at the right front of
the platform. It contains the following controls:
Figure 2-4. Operator’s Control Box
1. LIFT/DRIVE Controller - A one-hand toggle-type
lever controls the lift/drive and steer motions.
Internal springs return it to neutral when stick is
released.
2
. LIFT/DRIVE Enable Trigger Switch - This
momentary switch energizes the LIFT/DRIVE
proportional controller. It must be held depressed
continuously while engaging either the drive or
lift functions.
3. Warning Alarm Indicator Light - This red-colored
light indicates overload status. When the light
flashes, it signals an overload function
4. BASE/OFF/PLATFORM Select Key Switch - This
three-way selector switch allows the operator to
turn off the power to the aerial platform or to
activate either the base or platform controls.
5. Emergency Stop Button - When depressed, this
red “mushroom-head” push-button switch
disconnects power to the control circuit.
6. LIFT/OFF/DRIVE Select Toggle Switch -
Selecting “LIFT” position allows the lift enable
push button function to operate. Selecting “OFF”
position disconnects power to the control box.
Selecting “DRIVE” position allows the drive/steer
functions.
7. Horn Push-Button - Located on the side of the
operator’s control box, this push-button switch,
when depressed, sounds an automotive-type
horn.
2
1
3
6
7
4
5
To Next Page
Loading...
