SKYJACK, Page 31
April 2006
Start Operation Section 2 - Operation
SJ800 - E Series
Battery Powered
2.5-12 Electrical Inverter (If Equipped)
1. Ensure that the battery connector is properly
connected.
2. Make sure the ON/OFF switch of the inverter is ON.
3. Inverter activation is indicated by a glowing green
LED on the front of the inverter.
Caution
The battery connector MUST be properly
disconnected at the end of the shift or the
batteries will drain.
2.5-13 Shutdown Procedure
1.
Completely lower the platform.
2. Push in emergency stop button located on
operator’s control box.
3. Turn BASE/OFF/PLATFORM select key switch to
“OFF” position and remove the key (if equipped)
from the control box.
Warning
Ensure that you maintain three points of contact
when using the ladder to mount/dismount
the platform.
4. Dismount the platform using the ladder.
5. Disconnect the battery connector.
2.5-11c Retracting the Outriggers
1. Ensure the emergency stop button is pulled out.
Select the “LIFT” position with LIFT/OFF/DRIVE
select toggle switch.
2. Lower the aerial platform.
3a. Auto Retract: Select and hold the outrigger enable
toggle switch in either the “UP” or “DOWN” position,
then activate the the auto-level toggle switch in the
UP position until the outriggers are fully retracted.
3b. Manual Retract: Select and hold the outrigger
enable toggle switch in either the “UP” or “DOWN”
position, then push and hold pairs (front or rear) of
outrigger UP/DOWN toggle switches to “UP”
position until the outriggers are fully retracted.
Note
Limit switches are used to protect the outriggers
from being damaged. If aerial platform will not drive,
visually check to see that ALL outriggers are fully
retracted.
To Next Page
Loading...
