SJ800 - E Series
Battery Powered
April 2006
SKYJACK, Page 6
Read and Heed
SKYJACK Inc. is continuously improving and expanding product features on its equipment, therefore,
specifications and dimensions are subject to change without notice.
Aerial Platform Definition
A mobile device that has an adjustable position platform supported from ground level by a structure.
Purpose of Equipment
The SKYJACK SJ800 - E Series Rough Terrain (Models 8831E & 8841E) aerial platforms are designed to transport
and raise personnel, tools and materials to overhead work areas
Use of Equipment
The aerial platform is a highly maneuverable, mobile work station. Lifting and driving MUST be on a flat, level,
compacted surface. The aerial platform can be driven over uneven terrain only when the platform is fully lowered.
Manual
The operating manual is considered a fundamental part of the aerial platform. It is a very important way to
communicate necessary safety information to users and operators. A complete and legible copy of this manual
must be kept in the provided weather-resistant storage compartment on the aerial platform at all times.
Operator
The operator MUST read and completely understand both this operating manual and the safety panel label
located on the platform and ALL other warnings in this manual and on the aerial platform. Compare the labels
on the aerial platform with the labels found within this manual. If any labels are damaged or missing, replace
them immediately.
Optional Accessories
The SKYJACK aerial platform is designed to accept a variety of optional accessories. These are listed under
“Standard and Optional Features” in Section 1.13.
Operating instructions for these options (if equipped) are located in Section 2 of this manual.
For options not listed under “Standard and Optional Features”, contact the SKYJACK Service Department at
: 44 1691-676-235
: 44 1691-676-239
Include the model and serial number for each applicable machine.
Scope of this Manual
a. This manual applies to the CE version of the SJ-800E series aerial platform models listed on
Table 2-1.
- Equipment identified with “CE” meets the requirements for the European countries, i.e., Machinery
Directive 98/37/EC and EMC Directive 89/336/EEC and the corresponding EN standards.
b. Operators are required to conform to national, state or territorial/provincial and local health and
safety regulations applicable to the operation of this aerial platform.
To Next Page
Loading...
