April 2006
SKYJACK, Page 26
Section 2 - Operation Start Operation
SJ800 - E Series
Battery Powered
Warning
Do not operate this aerial platform without proper
authorization and training.
Failure to avoid this hazard could result in death or
serious injury.
2.5-2 Operator’s Checklist
It is the user’s responsibility to inspect the machine
operation before the start of each shift:
1. Operating and emergency controls.
2. Safety devices and limit switches.
3. Personal protective devices.
4. Tires and wheels.
5. Outriggers (if equipped) and other structures.
6. Air, hydraulic and fuel system(s) for leaks.
7. Loose or missing parts.
8. Cables and wiring harnesses.
9. Placards, warnings, control markings and
operating manuals.
10. Guardrail system including locking pins.
11. Battery fluid level.
12. Hydraulic reservoir level.
13. Parking brakes (check operation).
2.5 Start Operation
Carefully read and completely understand ALL of this
Operating Manual and ALL warnings and instruction
labels on the aerial platform.
Before operating this aerial platform, perform the pre-
start inspection and the tasks on the operator’s check-
list as described in this section.
2.5-1 Pre-Start Inspection
It is the responsibility of the operator to perform a pre-
start inspection.
The pre-start inspection is a visual inspection performed
by the operator prior to each work shift.
1. Ensure that there are no obstacles around the
aerial platform and in the path of travel such as
holes, drop offs, debris, ditches and soft fill.
2. Ensure that there are no electrical cords and hoses
in the path of travel.
3. Ensure that the batteries are fully charged.
Disconnect the AC charger cord from the external
power source.
4. Ensure that the battery tray, hydraulic/electric and
battery charger/hydraulic tank cabinets are closed
and locked.
5. Make sure all guardrails and locking pins are in
place and locked in position.
6. Make sure you do not climb or descend a grade
steeper than rated maximum listed in Table 2-1.
Elevated driving must only be done on firm level
surfaces.
7. Check overhead clearances.
Warning
Do not use or operate the aerial platform if any
component appears to be altered, damaged or if it
is tagged or locked out for non-use or repair.
Operation of aerial platform while in any of the
above states may result in death or serious injury.
To Next Page
Loading...
