SJ82 T, SJ86 T 213205AAA
39
Visual and daily maintenance inspections Section 4 – Inspections Before Operation
4.2-5 Engine compartment
Do the inspection that follows:
Make sure all compartment latches are latched tightly
and in good condition.
1
Main power disconnect switch
▪
Turn the main power disconnect switch to the
off position.
▪
Make sure the switch rotates and stays in the
on and off position.
▪
Make sure the cables are not loose.
2
Batteries
WARNING
Explosion hazard. Keep ames and sparks away.
Do not smoke near the batteries. Batteries release
explosive gas while you charge them. Charge the
batteries in a well-ventilated area. If you do not
obey, there is a risk of death or serious injury.
WARNING
Corrosion hazard. Do not touch battery acid. Wear
the correct PPE. If the battery acid touches you,
immediately ush the area with cold water and get
medical aid.
1. Do an inspection of the battery case for
damage.
2. Make sure all the battery connections are
tight.
3. If applicable, check the battery uid levels. If
the plates do not have a minimum 13 mm
(1/2 inch) of solution above them, add
distilled or demineralized water.
WARNING
Only use original or manufacturer-approved parts
and components for the MEWP. If you do not obey,
there is a risk of death, serious injury, or machine
damage.
3
Hydraulic pump and motor
▪
Make sure there are no loose or missing parts.
▪
Make sure there is no visible damage.
▪
Make sure all bolts are correctly tightened.
▪
Make sure all ttings and hoses are correctly
tightened and there are no hydraulic leaks.
4
Swing drive
▪
Make sure there are no loose or missing parts.
▪
Make sure there is no visible damage.
▪
Make sure all bolts are correctly tightened.
▪
Make sure all ttings and hoses are correctly
tightened and there are no hydraulic leaks.
1
2
3
4
To Next Page
Loading...
Need help?
General
