CDP-300 User’s Guide
Document Rev. 01.008 DOC0500 Page 18 of 42
Restricted Proprietary and Confidential Information
Delete
4.4.1.1 NEW
Creates a new entry in the address book. Prompts for the name, phone number and email address of the person
you wish to add to the Address book.
4.4.1.2 EDIT
Edits an existing address book entry.
4.4.1.3 DELETE
Permanently deletes an existing entry.
4.4.2 BRIGHTNESS
There are up to five options selectable from the “Brightness” menu:
Use Optical Mode
Use Dimmer Mode
Manual Adjust
Dimmer Ext Rng Mode (not available in FW Ver 5.x)
Configuration
4.4.2.1 USE OPTICAL MODE
In optical sensor brightness mode, the CDP-300 senses the aircraft cabin ambient lighting using the light sensor
present in the Display panel and sets the brightness of the display, indicators and backlight proportional to the
aircraft cabin ambient lighting.
The Optical sensor updates the brightness about every 5-7 seconds to prevent display flickering in varying
ambient lighting conditions that are short duration.
4.4.2.2 USE DIMMER MODE
In the Dimmer Bus Mode, the brightness of the CDP-300 backlights and LEDs will simply follow the voltage on the
dimmer bus until the voltage set by the “Dimmer Bus Volt” Menu is reached. Afterwards, the display and
backlights will remain at maximum brightness.
UNCONTROLLED COPY IF PRINTED
To Next Page
Loading...