CDP-300 User’s Guide
Document Rev. 01.008 DOC0500 Page 7 of 42
Restricted Proprietary and Confidential Information
1 INTRODUCTION
1.1 SCOPE
This document describes the operation of SKYTRAC System’s (STS) Cockpit Display Panel (CDP-300) in
standalone mode of operation and also when it is combined with a Dispatch Voice Interface (DVI-300).
1.2 TERMINOLOGY
If the CDP-300 is installed as a single unit it is referred to as the CDP-300 – Stand alone. If it has been combined
with a DVI-300 it is often referred to by the more informal term CDP/DVI.
This user’s guide describes the operation of both of these configurations as a voice and data control interface to
the ISAT-200.
Refer to DVI-300 User’s Guide (DOC0499) for DVI-300 standalone operation.
1.3 DESCRIPTION
The CDP-300 is an interface to the ISAT-200 that enables the user to send and receive satellite phone calls and
email messages. The CDP-300 also enables the user to view certain parameters of the ISAT.
CDP-300 and DVI-300 combined into CDP/DVI
UNCONTROLLED COPY IF PRINTED
To Next Page
Loading...