CDP-300 User’s Guide
Document Rev. 01.008 DOC0500 Page 36 of 42
Restricted Proprietary and Confidential Information
5 CONNECTING MULTIPLE DEVICES TO THE
ISAT-200
The CDP can be connected to the ISAT-200; along with additional devices such as another CDP-300, a DVI-300
or CDP/DVI.
A maximum of four devices can be connected to the ISAT-200.When multiple devices are connected to the ISAT-
200, each device (depending on its capabilities) can be used to make calls and send emails / text messages as
described in the previous sections of this user guide.
To receive emails properly each device connected to the ISAT must be assigned a different unique message
mailbox/device number between 0 and 3. See Section 4.4.3.7 on how to set the mailbox number.
For example: If the ISAT was connected to both a CDP/DVI and a CDP-300 Standalone, one possible mailbox
assignment for them would be:
CDP/DVI = Mailbox 0 / Device 0
CDP-300 = Mailbox 1 / Device 1
In this example - If the ISAT’s call sign is “Heli-5”, in order to send an email to the CDP/DVI using the default
message mailbox (0), the email address would be
Heli-5@skytrac.net.
To send an email to the second device (the CDP-300), the assigned mailbox number needs to be added to the
email address of the ISAT. In this example, the CDP-300 has been assigned message mailbox 1. Therefore, the
email address of the CDP will be
Heli-5.1@skytrac.net.
Configuring both devices to have the same message mailbox number is not supported.
Devices that are configured to have their own message mailboxes will have private messaging only. Voice
communication, regardless of the number of interfaces attached, is still controlled by the single ISAT-200. All
voice calls will go through the aircraft audio panel and will not be private.
UNCONTROLLED COPY IF PRINTED
To Next Page
Loading...