CDP-300 User’s Guide
Document Rev. 01.008 DOC0500 Page 23 of 42
Restricted Proprietary and Confidential Information
The user may enter an alpha numeric flight number in the format AA1111. Once the user confirms the number
they have entered; the flight number will be added to the position data and sent to the ground with each position
report.
This flight number will automatically clear when the aircraft next powers down.
4.4.5 DISPLAY OFF
Main Menu System Display Off
The CDP-300 display can be turned off if desired. This may be for preference or specific flying conditions. If this
option is selected the user will have to confirm the request. The display will then turn off after approximately 3
seconds.
While operating in display off mode, incoming phone calls can be answered and terminated and incoming emails
will be received and the display will remain off.
The user can turn the display back on by pressing and holding (for approx 2 seconds) the ◙ Enter key.
4.5 DISPLAY ALERTS
Main Menu Display Alerts
This is only displayed if there are active alerts to view. Selection of this option will show both the number of alerts
and what they are. If more than one, the user will be able to scroll through them.
The following alert messages are displayed when the relevant conditions exist:
Note: The following alerts appear on all firmware revisions;
Important: Setting a flight number will automatically increase the packet size of the data that is transmitted. Regardless if premium
packets are enabled in SkyWeb or not, this will possibly result in a higher cost for the end-user.
UNCONTROLLED COPY IF PRINTED
To Next Page
Loading...