Skytrac CDP-300 - Page 24

CDP-300 User’s Guide
Document Rev. 01.008 DOC0500 Page 24 of 42
Restricted Proprietary and Confidential Information
VOICE MSG IN QUEUE
Indicates a Voice Message is queued and waiting to be sent
SAT SIGNAL WEAK
Iridium signal strength less than 2 (out of 5)
ISAT DATA DELAY
ISAT unable to send position reports for 300 seconds
NO GPS SIGNAL
Loss of GPS signal
GPS COMM FAULT
Loss of communication with internal GPS module
ISAT NOT
FOUND
CDP/DVI not able to communicate with ISAT-200
During encryption changes, alert message ‘ISAT Not Found’ may be displayed while the
ISAT switches to the new encryption mode.
Note: The following alerts are only shown when using firmware 5.x
SAT SIGNAL LOST
Loss of communication with the Iridium satellite network
FP FLASH MISSING
Missing ISAT Front Panel serial flash memory
MB FLASH MISSING
Missing ISAT Mainboard serial flash memory
TRAY MISSING
Missing ITRAY-200 serial flash memory
POS DATA DELAY
ISAT unable to send position reports for ‘X’ position intervals (configurable)
QUEUE CONFIG ERROR
More than one device assigned to same peripheral device queue
Note: The following alerts are only shown when using firmware 5.x, 6.00.26 or higher.
ISAT REG FAILURE
Failure of modem registration with the Iridium network
GPS CFG FAILURE
Failure of GPS module configuration
UNCONTROLLED COPY IF PRINTED