CDP-300 User’s Guide
Document Rev. 01.008 DOC0500 Page 28 of 42
Restricted Proprietary and Confidential Information
4.7.6 AUDIO CONTROL
The CDP-300 allows changing the following audio controls only when a call is in progress.
The 3 settings that can be adjusted are:
Mic (On/Off) – Microphone Mute
Volume (1-10) – Main Call Volume
S-Tone (1-6) – Side Tone Volume
Xfer – Transfer to POTS/DPL, if configured. 200A Only
During a call all options are displayed automatically. To change any of the settings the user must use the left/right
arrow keys (►,◄) to select the item they wish to adjust. Then either use the up/down arrows (▲,▼) to adjust the
setting or use the numbers on the keypad (CDP/DVI Only). The currently selected item will be indicated to the
user by having vertical bars around it.
Note: It may take up to 30 seconds for the volume to adjust although typically it takes approximately 5 seconds.
4.8 RENDEZVOUS (FW VERSION 5.X ONLY)
Rendezvous is a feature available only to CDP’s with firmware version 5.x installed. This feature allows users to
know the location and bearing of other units in the fleet. In order to see these other units they must all belong to
the same resource group and have rendezvous enabled for that group. All assets in the rendezvous group must
also be set for the same level of encryption. (See Section 4.11)
If the CDP is on the rendezvous screen, the rendezvous coordinates will update automatically with each message
received. If the CDP is on any other screen a brief ‘Cfg Msg Received’ will appear when each rendezvous
message arrives.
The CDP is also able to receive and respond to other units’ emergency alerts. If an emergency alert is received
from another unit by the CDP, all normal functionality is disabled until the operator has acknowledged receipt of
the emergency alert.
Note: this only applies if the CDP is configured as a Vessel Tracking Unit (VTU)
Rendezvous is configured by the Program Manager in SkyWeb’s Account Management section.
UNCONTROLLED COPY IF PRINTED
To Next Page
Loading...