CDP-300 User’s Guide
Document Rev. 01.008 DOC0500 Page 25 of 42
Restricted Proprietary and Confidential Information
ISAT Battery voltage critically low
4.6 EMERGENCY MODE
Main Menu Emergency Mode
Note: This menu option is only available in the CDP-300 mode as the toggle/push button emergency switch
provides this functionality on the CDP/DVI.
The Emergency Mode can be selected either by:
Pressing the ► arrow key (CDP only) for greater than 2 seconds whilst in the Main Menu, or
Selecting the Emergency Mode option in the Main Menu(CDP only), or
Setting the toggle switch (CDP/DVI with toggle switch on the DVI), or
Pressing the pushbutton for greater than 2 seconds (CDP/DVI with push button on the DVI.)
If no confirmation or cancel is received within 3 seconds, the CDP will request the Emergency Mode from the
ISAT (unless it was activated via the toggle switch in which case the request is immediate). The CDP Display
indicates “ISAT Emergency” along with device number(s) currently set in Emergency Mode.
The ISAT does allow you to make voice calls in Emergency Mode. If the user is in a voice call when the
Emergency Mode is triggered, the ISAT will not end the voice call when Emergency Mode has been triggered.
The user cannot navigate the CDP menu system during ISAT Emergency mode, apart from selecting the▲, ▼
Keys to initiate a voice call.
To turn off emergency mode, press and hold the ► arrow key (CDP only) or push button (CDP/DVI), or reset the
toggle switch (CDP/DVI only) until the “ISAT Emergency” message goes off. In a multi-unit configuration if more
than one device is set to emergency mode they will all need to have the Emergency turned off to end the ISAT
Emergency condition.
4.7 PHONE
Main Menu Phone
The Phone Menu has the following sub-menus:
UNCONTROLLED COPY IF PRINTED
To Next Page
Loading...