CDP-300 User’s Guide
Document Rev. 01.008 DOC0500 Page 26 of 42
Restricted Proprietary and Confidential Information
Speed Dial (CDP/DVI Only)
Manual Dial (Not available on CDP-300)
Address Book Dial
Redial (if a previous number has been called)
To make a call on the CDP/DVI the user can either enter the desired number using the key pad and then press
the ‘Send’ key or select the Manual Dial option from the Phone Menu, dial the required number and then press the
Enter ◙ key.
The Phone menu also allows the user to call any number selected from the address book.
It may take a moment for the ISAT to initiate the call if it is already busy communicating with the Iridium network.
To hang-up / terminate a call, press the Enter ◙ key again.
When a call is initiated by the ISAT, the user will hear a periodic beep and the display shows the status of the call.
The user will hear a normal telephone ring when a call connects.
If the call fails, the user will hear beeps to indicate the signal was lost. The call will end and the display will show
the call is disconnected.
4.7.1 SPEED DIAL
Note: This option is available to the CDP/DVI only.
The CDP/DVI supports 9 speed dial numbers for single button access from the DVI keypad. These are the first 9
numbers of the address book.
Press any DVI key 1 through 9 followed by the DVI ‘Send’ key to dial the associated number directly, or press any
DVI key 1 through 9 followed by the CDP ◙ key to display the speed dial number first (for confirmation) then press
◙ or Send to dial the number.
4.7.2 MANUAL DIAL
The user can select this option, dial a number and then press the Enter ◙ key to call it.
4.7.3 ADDRESS BOOK DIAL
Main Menu Phone Address Book Dial
UNCONTROLLED COPY IF PRINTED
To Next Page
Loading...