CDP-300 User’s Guide
Document Rev. 01.008 DOC0500 Page 22 of 42
Restricted Proprietary and Confidential Information
4.4.3.4 ISAT INFO
The ISAT Info option displays information from the connected ISAT. The user can select to view either the ‘Status
and Config’ or ‘Technical info’ report.
The reports include such information as the current position in Lat /Long format, the date and time, GPS satellites,
Iridium signal strength, the installed ISAT firmware version etc.
4.4.3.5 CDP INFO
Selecting ‘CDP Info’ displays the installed CDP-300 firmware version and the CDP serial number.
4.4.3.6 DVI INFO
Selecting ‘DVI Info’ displays the installed DVI-300 firmware version and the DVI serial number.
Note: This option is only available on the CDP/DVI.
4.4.3.7 SET MAILBOX NUM
The system can support multiple devices connected to the same ISAT. This option allows the user to configure
these multiple devices. Each device requires a unique mailbox and therefore the user can configure one of four
mailboxes (0-3) to associate with the device. These numbers are also sometimes referred to as the Data Terminal
Equipment (DTE) number (e.g. in SkyMail).
Note: If the user changes the mailbox number the unit will automatically restart to make the change effective.
Note: Rendezvous functionality is only supported through Mailbox 0.
4.4.4 ENTER FLIGHT NUM
Main Menu System Enter Flight Num
Important: Please cycle power to the unit off and on again to complete the Factory Reset.
UNCONTROLLED COPY IF PRINTED
To Next Page
Loading...