CDP-300 User’s Guide
Document Rev. 01.008 DOC0500 Page 31 of 42
Restricted Proprietary and Confidential Information
Curr PI Ctrl: ISAT
Set PI Ctrl: USER
The cursor will be blinking at the Set PI Ctrl: USER position, use the up/down arrows (▲,▼) to scroll through the
options, USER, ISAT or OFF. Press the Select ◙ key to set the PI Ctrl to the desired setting.
If choosing OFF or ISAT, the CDP will display a confirmation message. Select Yes to apply the change or No to
cancel.
If selecting USER, the next screen will display the current PI interval as well as the new setting with the cursor
blinking at the hour field.
If selecting OFF the ISAT will stop reporting completely. It is not recommended to do this without informing
SkyWeb flight followers, as they may perceive an overdue situation for the aircraft/vessel if it suddenly stops
reporting. Reports for specific events, such as Wheels On/Off will still be sent if the position interval is OFF.
Changing the position interval through the CDP will not affect Emergency reporting intervals.
Use the left/right arrow keys (►,◄) to move the cursor to the next field, and the up/down arrows (▲,▼) to change
the field’s value. The minimum and maximum values can be changed in the CDU Config menu, with an absolute
min and max of 30 seconds to 4 hours.
4.10 CDU CONFIGURATION (FW VERSION 5.0+ ONLY)
Main Menu System CDU Config
There are four selections available in the CDU Config
RV Persist
Set Posn Delay
Posn Int Persist
Posn Int Range
Asset Type
4.10.1 RV PERSIST
Selecting Yes will cause the ISAT to automatically re-engage an active rendezvous across power cycles.
Additionally, if a Rendezvous menu is being viewed at power down, the same information will be shown when the
unit is powered up.
UNCONTROLLED COPY IF PRINTED
To Next Page
Loading...