Skyworks Si5341 - Revision History

16. Revision History
Revision 1.3
July 2020
• Changed the input termination diagram in section 4.2 Clock Inputs on IN2, IN1, IN0
Revision 1.2
May 2020
• Removed section on Output Delay Control
• Removed section on Supply Voltage
• Changes made to section 3.2 NVM Programming
• Added details to the ZDM section 5.5 Zero Delay Mode
• Removed tool version tables
• Removed SOFTCAL setting in register 0x001C[5]
• Register 0x001E bit field 1 type changed from S to R/W and bit 2 description changed
• Corrected description for register 0x00E2
• Changed Type of registers 0x00F6, 0x00F7 and 0x00F8 from R/W to R
• Added table for register 0x00FE (Device Ready)
• Added table for register 0x013F and 0x0140
• Added Note below table 15.41 and 15.131
• Added description for register 0x0141
• Removed the User Scratch table
• Added table for registers 0x013F and 0x0140
• Description and type added for P0, P1, P2 and P3 divider Enable/Set tables
• Description added for table for M divider numerator
• Text below table for R0_REG updated
• Text added below Design_ID registers table to indicate User Scratch
• Removed tables about Nx_DELAY registers
• Description added for register 0x095E
• Text added below about register 0x0A04
• Added description for register 0x0B2E
• Added description for register 0x0B44
Revision 1.1
July 20, 2017
• Updated Dynamic PLL Section.
Revision 1.0
July 28, 2016
• Initial release.
Si5341, Si5340 Rev D Family Reference Manual • Revision History
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • sales@skyworksinc.com • www.skyworksinc.com
110 Rev. 1.3 • Skyworks Proprietary Information • Products and Product Information are Subject to Change Without Notice • July 26, 2021 110