(Model K) Page 183
24.2.1 Controls (Via touch screen display)
Adjust button: Activates alarm thresholds for modification
Alarm Auto-Track button: Sets selected %0
2
for testing
Apnea Sup Button: Sends diagnostic pulse
Apnoea setup button: Activates Backup/Apnoea settings panel
Arrow buttons: Increments value up or down or scrolls left/right
Auto set Button: Autoset high, cycle and low alarm thresholds
Backup parameter control: 1 to 150 bpm (Resolution 1BPM)
Begin psv Button: Sends diagnostic pulse
BPM parameter control: 1 to 150 bpm (Resolution 1BPM)
Calibrate button: Calibrates flow sensor
Calibrate Flow Sensor button: Activates calibrate flow sensor panel
CMV button: Selects CMV mode
Confirm button: Confirms selection
Continue without flow button: Selects pressure monitoring operation
Controller button: Activates controller services panel
Compliance Trend button Selects Compliance against time display
CPAP button: Selects CPAP mode
CPAP parameter control: 0 to 20 mbar (Resolution 1mbar)
Default button Selects the default waveform layout.
Delta P parameter control: 4 to 180 mbar (Resolution 2mbar)
End psv Button: Sends diagnostic pulse
Expiratory Only button: Selects oscillations in expiratory phase only
FiO2 button: Selects fractional concentration of inspired oxygen
against time display
FiO2 parameter control: 21% to 100% (Resolution 1%)
Flow button: Activates flow sensor calibration panel
F/P Loop button: Selects flow versus pressure loop display
Flow Trigger button Activates the breath detection threshold
F/V Loop button: Selects flow versus volume loop display
Graphs button: Activates waveform and loops panels
Hist. button: Display alarm history panel
Langauage button: Change interface langauge
Manual Breath button: Delivers one manual breath
Mean parameter control: 0 to 35 mbar (Resolution 1mbar)
Min Vol button: Selects minute volume against time display
Mode select button: Activates mode select panel
Monitor button: Activates monitor services panel
To Next Page
Loading...
