Smart Electronic SMARTMETER T20 - Meter Settings and Configuration; System Settings Management

Menu Spectrum
smartmeter T20 23
9 Menu Spectrum
Use the smartmeter T20 as follows to display the spectrum of the aerial
signal.
1. Press the
MENU key.
2. Press the ◄/► and ▲/▼ keys to select the menu item
Spectrum .
Press
OK to confirm your selection. The display shows the Spectrum
window.
 Press ◄ /
F1 to switch to a lower Channel/Frequency.
 Press ► /
F2 to switch to a higher Channel/Frequency.
 Press ▲ and ▼to change the displayed frequency range.
 Press
F3 to switch the speed for measuring the whole frequency range
between
low speed and high speed .
 Press
F4 to save the current spectrum to your USB data storage de-
vice.
10 Menu Settings
Here you can adjust general settings for the meter.
1. Press the
MENU key.
2. Press the ◄/► and ▲/▼ keys to select the menu item
Settings. Press
OK to confirm your selection.

 Press the
SYSTEM
key to enter the
Settings
submenu
directly from TV mode.
The display shows the Settings window with the items System , Factory
Default and System Info.
10.1 Menu System
1. Select the menu item System and confirm with OK.
2. Press ▲/▼ to select the menu item you want to adjust:
10.1.1 Language
 Press ◄/► to adjust the menu language.