Smart Electronic SMARTMETER T20 - TV Mode Functions and Operation

Checking the TV Signal
32 smartmeter T20
1. Press MENU to enter the main menu.
2. Select the
TP Search submenu. Press OK to confirm your selection.
3. Select a channel, i.e. a frequency, in which you want to search for sta-
tions.
4. Press the
F3 key (manual search). The display shows a prompt for you
to choose whether you want to search for all types of stations.
 Press ◄/► to select
YES or NO.
If you select
YES, manual search starts. The manual search can find
coded as well as free-to-air (FTA) stations in the selected channel.
If you select
NO, manual search starts but can find only free-to-air
(FTA) stations in the selected channel.
After manual search in the selected channel is finished, the smartmeter
T20 issues a channel list containing the stations found.
5. If you want to search for stations in other channels, repeat steps 1 to 4.
The stations found are added to the channel list.

Adjust the menu item
Signal Audio Tone
in the
Settings / System
menu to select/unselect an audible
signal indicating that a station is found during station
search.

In the submenu
TP IDE
you have the same search func-
tions as in the submenu
TP Search
.
..
13.3 TV Mode
When the meter is in TV mode, you can also use the following functions:
 Press ▲/▼ to select the previous or next station in the station list.
When you switch between stations, the display shows details on the
selected station for about four seconds. Apart from the displayed
channel values, the station details include audio, video and PCR PID
2
(packet identifier).
 Press ◄/► to adjust the volume.
2
PID = Packet Identifier: Tells the user which data packets are to be used.