Smart Electronic SMARTMETER T20 - Deleting a Transponder from the TP List; Adding a Transponder to the TP List; Searching Channels; 7 Menu TP IDE

Menu TP IDE
smartmeter T20 19
6.1 Deleting a Transponder from the TP List
1. In the TP Search submenu, enter the Channel field, press ◄/► to se-
lect the transponder you want to delete.
2. Press the
F1 key (delete). The display shows a prompt for you to con-
firm that you want to delete this transponder.
3. Press ◄/► to select
YES. Press OK to confirm your selection.
6.2 Adding a Transponder to the TP List
1. In the TP Search submenu, press the F2 key (add).
2. Use the number keys and the ◄ (delete) key to edit the frequency val-
ue (
Frequency). Press OK to confirm your selection. The new tran-
sponder is now added to the TP list.
6.3 Searching Channels
In the submenu TP Search you also can search for channels. This is de-
scribed in the chapter „Checking the TV Signal“, starting page 31.
7 Menu TP IDE
7.1 Measurement Values
The smartmeter T20 displays different nominal values and measuring val-
ues for each channel.
1. Press
MENU to enter the main menu.
2. Select the
TP IDE submenu (transponder). Press OK to confirm your
selection. The display shows the
TP IDE window.
3. Press ◄/► to select the channel you want to check (channel is given in
the yellow field in the top right corner).
or
Press OK. In the selection window, press ▲/▼ to select the channel
you want to check. Press
OK to return to the TP IDE submenu (tran-
sponder).