Issue Solution
No image appears when
you press the button.
l
Insert an SD/SDHC card or USB drive with stored images, or
capture an image to the embedded memory.
1.
N O T E
Images need to be stored in the available memory location in
order to enter Playback mode.
l
Disconnect the USB cable or set the USB switch to .
Your document camera
doesn't detect the inserted
USB drive.
Ensure the USB switch is set to .
You're unable to record a
video (the red recording light
doesn’t turn on).
l
Ensure an SD/SDHC card or USB drive is installed.
l
Disconnect the USB cable (the document camera doesn't
record video while being used as a USB camera or mass
storage device).
The SD/SDHC card or USB
drive doesn't play video
properly, or the document
camera stops responding
during video recording.
Format the SD/SDHC card or USB drive using the document
camera's OSD menu (Menu > SETTING > Format > SD
CARD / USB DRIVE).
1.
C A U T I O N
This erases all the data on the SD/SDHC or USB drive.
Your document camera has
an issue not described
above.
Restart the document camera using the power button on
the control panel.
C H A P T E R 8
Troubleshooting
77
To Next Page
Loading...
