High-pressure cleaning equipment
G
WARNING
The water jet of circular-jet nozzles (dirt
grinders) can cause damage not visible
from the outside to tyres or chassis com-
ponents. Components damaged in this way
can
unexpectedly
fail. There is a risk of an
accident.
Do not use high-pressure cleaners with
circular-jet nozzles to clean the vehicle.
Have damaged tyres or chassis components
replaced immediately.
!
Always maintain a distance of at least
30 cm between the vehicle and the high-
pressure cleaner nozzle. Information about
the correct distance is available from the
equipment manufacturer.
Move the high-pressure cleaner nozzle
around when cleaning your vehicle.
Do not aim directly at any of the following:
R
tyres
R
door gaps, roof gaps, joints etc.
R
electrical components
R
battery
R
connectors
R
lights
R
seals
R
ventilation slots
Damaged seals or electrical components
can lead to leaks or failures.
Cleaning the paintwork
!
Do not affix:
R
stickers
R
films
R
magnetic plates or similar items
to painted surfaces. You could otherwise
damage the paintwork.
X
Remove impurities immediately, where
possible, whilst avoiding rubbing too
hard.
X
Soak insect remains with insect remover
and
rinse
off the treated areas afterwards.
X
Soak bird droppings with water and rinse
off the treated areas afterwards.
X
Remove coolant, brake fluid, tree resin,
oils, fuels and greases by rubbing gently
with a cloth soaked in petroleum ether or
lighter fluid.
X
Use tar remover to remove tar stains.
X
Use silicone remover to remove wax.
The following cannot always be completely
repaired:
R
scratches
R
corrosive deposits
R
areas affected by corrosion
R
damage caused by inadequate care
In such cases, visit a qualified specialist
workshop.
Care and treatment of matt paintwork
!
Never polish
the vehicle or the light alloy
wheels. Polishing makes the paintwork
shiny.
!
The following may cause the paint to
become shiny and thus reduce the matt
effect:
R
vigorous rubbing with unsuitable mate-
rials
R
frequent use of car washes
R
washing the vehicle in direct sunlight
!
Never use paint cleaner, buffing or pol-
ishing products, or gloss preserver, e.g.
wax. These products are only suitable for
high-gloss surfaces. Their use on vehicles
with matt paintwork leads to considerable
surface damage (shiny, spotted areas).
Always have paintwork repairs carried out
at a qualified specialist workshop.
!
Do not use wash programs with a hot wax
treatment under any circumstances.
Observe these notes if your vehicle has a
clear matt finish. This will help you to avoid
damage to the paintwork due to incorrect
treatment.
These notes also apply to light-alloy wheels
with a clear matt finish.
i
The vehicle should preferably be washed
by hand using a soft sponge, car shampoo
and plenty of water.
178
Care
>> Maintenance and care.
To Next Page
Loading...
