After releasing, the middle ring returns
automatically back
to the neutral position.
X
To switch off: turn combination switch
middle ring E until marking D is at
R.
The R indicator lamp in the instrument
cluster goes out.
After releasing, the middle ring returns
automatically back to the neutral position.
i
If you switch off the engine (only in the
à position) or turn off the lights, the
rear foglamps are also switched off.
Adjusting the headlamp range
The headlamp range control allows you to
adjust the
cone of light from the headlamps to
suit the vehicle load. The cone of light
changes when seats are occupied or when the
luggage compartment is loaded or unloaded.
This can impair visibility and dazzle oncom-
ing traffic.
g
Driver's seat occupied/driver's
seat and front-passenger seat
occupied
1
Other loading
2, 3, 4
Settings are not required
X
Turn the key to position 2 in the ignition
lock or start the engine .
X
Turn headlamp range control : to the
position which corresponds to the load in
your vehicle.
Switching on the turn signals
X
Start the engine.
X
To indicate briefly: press
the combination
switch briefly to the pressure point in the
direction of arrow : (right turn signal)
or ; (left turn signal).
The corresponding turn signal flashes
three times.
X
To indicate: press the combination switch
beyond the
pressure point in the direction
of arrow : (right turn signal) or ; (left
turn signal).
Switching on the main-beam headlamps
and headlamp flasher
Main-beam headlamps
X
To switch on: start the engine.
X
Turn the combination switch control until
K
or Ã
(if available) is at the mark-
ing.
74
Exterior lighting
>> Lights and windscreen wipers.
To Next Page
Loading...
Need help?
General
