Chapter 2
Using Your SMART Table
After setting up your SMART Table as documented in the SMART Table 230i
Installation Instructions (document 131863
), you can use it on a regular basis.
IMPORTANT
Your SMART Table is sensitive to infrared light. Therefore, turn off or remove any
pot lights or other incandescent lighting in the room and close any open blinds or
curtains before turning on your SMART Table.
Turning On Your SMART Table
After you set up your SMART Table, you can turn it on by following this procedure.
To turn on your
SMART Table
1. Connect the power cable to an outlet, or connect the power cable to a power bar,
and then turn on the power bar.
2. Push the Reset switch.
Your SMART Table’s computer and
projector turn on. The computer
completes its startup process, and the
SMART Table Activities icons appear.
NOTE
Your SMART Table’s surface doesn’t respond to touch until the computer
completes its startup process. Wait 30 to 60 seconds after turning on your
SMART Table before touching the surface. For more information on the
SMART Table Activities software, see page 7.
To Next Page
Loading...
