47 | CHAPTER 7 – MAINTAINING YOUR SMART TABLE
4. Select the Default application, and then press Open.
Your SMART Table applies the application and a confirmation message appears.
5. Press OK.
6. Disconnect the USB storage device bracelet.
The menu changes from Teacher mode to Student mode.
Orienting the Surface
Whenever you touch the SMART Table’s surface a small cross or circle should appear
directly under your finger. If it doesn’t appear where you touched the surface, you may
need to orient the surface.
NOTE
You should orient your SMART Table after you realign the projector.
To orient the surface 1. Turn on your SMART Table (see Turning On Your SMART Table on page 5).
The SMART Table Activities menu appears.
2. Connect the USB storage device bracelet to your SMART Table.
The menu changes from Student mode to Teacher mode.
3. Click Orient.
A message asks you to close the cabinet doors and position the table away from
direct sunlight.
4. Click OK.
The orientation screen appears.
5. Using your finger, press and hold the center of the first target until the red cross
moves to the next target.
To Next Page
Loading...
