7 | CHAPTER 2 – USING YOUR SMART TABLE
Navigating SMART Table Activities
SMART Table Activities is your SMART Table’s primary software. It starts
automatically when you turn on the table.
The SMART Table Activities menu has two modes:
• Student mode is the default mode. It allows
students to start applications specifically
designed for children in early primary grades.
• Teacher mode appears when you connect the
USB storage device bracelet to your SMART
Table. It allows you to set the number of
students, adjust the speaker volume, orient the
surface, synchronize activity packs and
applications and complete other configuration
tasks as documented in this guide.
Initial Setup Using Teacher Mode
In Teacher mode, you can select the language for the on-screen text that Teacher and
Student mode menus appear in, specify the number of students and adjust the
speaker volume before students use the SMART Table.
Selecting the Language
You select the language the SMART Table Teacher mode menus appear in when you
initially install SMART Table software. See Updating the Software on page 45 for
information. You can use Teacher mode to change the language after you complete
the software installation.
To select the language 1. Connect a USB storage device to your SMART Table.
The menu changes from Student mode to Teacher
mode.
2. Press the About SMART Table icon.
The SMART Table Software page appears.
3. Press the Language tab.
4. Select a language from the list, and then press OK.
To Next Page
Loading...
