39 | CHAPTER 5 – DOWNLOADING, SAVING AND COPYING ACTIVITIES
Copying Activities to the Table
After saving a .tableContent file to your USB storage device, you can copy the file to
your SMART Table.
NOTES
• After you copy a new activity to your table, only the applications with tabs
saved in the .tableContent file (see page 38) appear in the SMART Table
Activities menu.
• Your SMART Table saves all previous activities in an archive folder. You can
restore any of these activities.
To apply a new
activity pack
1. Turn on your SMART Table (see Turning On Your SMART Table on page 5).
The SMART Table Activities menu appears.
2. Connect the USB storage device to your SMART Table.
The menu changes from Student mode to Teacher mode.
3. Press Choose Activities.
4. Press the Bracelet tab, if it’s not already selected.
A list of all .tableContent and .tableApplication files on the USB storage device
appears.
TIP
Press to rotate the list 180°.
5. Select the appropriate .tableContent file or .tableApplication file, and then
press Open.
NOTE
The name of each .tableContent file and .tableApplication file must be unique.
You’re unable to apply a .tableContent file or .tableApplication file with the
same name as one you previously applied.
Your SMART Table copies the file, and a confirmation message appears.
6. Press OK.
7. Disconnect the USB storage device.
The menu changes from Teacher mode to Student mode.
To Next Page
Loading...
