48 | CHAPTER 7 – MAINTAINING YOUR SMART TABLE
6. Repeat step 5 for each target.
When you press the last target, the orientation data saves to your SMART Table’s
memory, and the SMART Table Activities menu reappears.
NOTE
If you need to stop the orientation procedure, press ten fingers on the table
surface simultaneously.
7. Disconnect the USB storage device bracelet.
The menu changes from Teacher mode to Student mode.
Cleaning Your SMART Table
Use an alcohol-free household glass cleaner, such as Windex® glass cleaner, to
clean the surface at regular intervals.
IMPORTANT
Before you clean your SMART Table, turn it off (see page 6) so that you do not
unintentionally start applications when you wipe the surface.
Replacing the Projector Lamp
Approximately 100 hours before the recommended lamp replacement time, the
projector displays a change lamp message. Contact your reseller (see page 57) for a
replacement lamp as soon as possible.
NOTE
In some situations, the projector lamp may start to dim before you see the
message. Replace the projector lamp in these situations as well.
Refer to the document included with the replacement lamp for instructions.
Aligning the Projector
To align the projector Refer to the textless installation instructions that were provided with your SMART
Table. You can also refer to document 141081 in SMART’s Knowledge Base.
To Next Page
Loading...
