8 | CHAPTER 2 – USING YOUR SMART TABLE
Specifying the Number of Students
Your SMART Table can support and respond to input from up to eight students.
Before using your SMART Table, specify the number of students that will use the table
at the same time. Doing so changes several options in the SMART Table Activities
software. For example, if you specify three students, Multiple Choice may require
three responses to each question depending on the current activity pack (see
page 11).
To specify the
number of students
1. Connect a USB storage device to your SMART Table.
The menu changes from Student mode to Teacher mode.
2. Locate the Total Learners control, and then press
+ or
– to increase or decrease the number of students.
3. Disconnect the USB storage device bracelet.
The menu changes from Teacher mode to Student
mode.
Adjusting the Speaker Volume
You can adjust the volume of the SMART Table speakers to provide a comfortable
listening level for noisy or quiet environments.
To adjust the
speaker volume
1. Connect a USB storage device to your SMART Table.
The menu changes from Student mode to Teacher mode.
2. Rotate the Volume Control control clockwise to increase
the volume.
Rotate it counter-clockwise to decrease the volume.
NOTE
You can also press the small speaker symbol at
the edge of the icon to mute or unmute the audio.
3. Disconnect the USB storage device bracelet.
The menu changes from Teacher mode to Student mode.
To Next Page
Loading...
