40 | CHAPTER 5 – DOWNLOADING, SAVING AND COPYING ACTIVITIES
To restore a previous
activity pack
1. Turn on your SMART Table (see Turning On Your SMART Table on page 5).
The SMART Table Activities menu appears.
2. Connect the USB storage device to your SMART Table.
The menu changes from Student mode to Teacher mode.
3. Press Choose Archives.
4. Press the Table tab, if it’s not already selected.
A list of previous activities appears.
TIP
Press to rotate the list 180°.
5. Select the activity you want to restore, and then press Open.
NOTE
The previous activities are stored on the SMART Table computer rather than
the USB storage device, but you need to connect a USB storage device to the
table to switch to Teacher mode.
Your SMART Table restores the selected activity, and a confirmation message
appears.
6. Press OK.
7. Disconnect the USB storage device.
The menu changes from Teacher mode to Student mode.
To Next Page
Loading...
