Smartgen HGM1790N User Manual

HGM1790N Genset Controller User Manual Page 16 of 31
7. PARAMETER RANGE AND DEFINITION
7.1 PARAMETERS CONTENTS AND RANGE
Table 7 Parameter Setting Contents and Range
No.
Parameter
Range
Default
Value
Description
P00
Start Delay
(0-3600)s
1
Time from remote start signal is active
to start genset.
P01
Stop Delay
(0-3600)s
1
Time from remote start signal is
deactivated to stop genset.
P02
Start Attempts
(1-10) times
3
The maximum number of crank
attempts. If none of them is successful,
the controller will initiate fail to start
alarm.
P03
Preheat Time
(0-300)s
0
Time of pre-powering heat plug before
starter is powered up.
P04
Cranking Time
(3-60)s
8
The time of powering up the starter for
every crank attempt
P05
Crank Rest Time
(3-60)s
10
The waiting time before second power
up when engine start fail.
P06
Safety On Delay
(1-60)s
10
Alarms for low oil pressure, high
temperature, under speed, under
frequency and under voltage are inactive.
P07
Start Idle Time
(0-3600)s
0
Idle running time of genset when
starting.
P08
Warming Up
Time
(0-3600)s
10
Warming time between genset switch on
and normal running.
P09
Cooling Time
(3-3600)s
10
Radiating time before genset stop, after
it unloads.
P10
Stop Idle Time
(0-3600)s
0
Idle running time when genset stop.
P11
ETS Solenoid
Hold
(0-120)s
20
The time of powering up the
electromagnet during stop procedure.
P12
Fail to Stop
Delay
(0-120)s
0
Time between ending of genset idle
delay and stopped when “ETS output
time” is set as 0;
Time between ending of ETS hold delay
and stopped when “ETS output time” is
not 0.
P13
Flywheel Teeth
(1-300)
118
Tooth number of the engine is for
judging of crank disconnect conditions
and inspecting of engine speed. See the
installation instructions.

Smartgen HGM1790N Specifications

General

Brand	Smartgen
Model	HGM1790N
Category	Controller
Language	English