HGM1790N Genset Controller User Manual Page 4 of 31
1. OVERVIEW
HGM1790N genset controller is suit for single unit automation and monitoring control (also
can be used for pumping unit). It can realize manual start/stop of genset, and it can also
automatically start/stop genset by remote start signal. HGM1790N controller can supervise and
protect genset operation by gathering and analyzing genset data like generate voltage, current,
water temperature, oil pressure and so on, and it can indicate fault conditions and do
maintenance as soon as possible. The graphical LCD and touch-button operation make it clear
and intuitive. Moreover, parameter threshold and delay value can be adjusted via front panel or
USB port (communicated with PC software).
2. PERFORMANCE AND CHARACTERISTICS
□ Graphical LCD display (with backlight), LED indicator, touch-buttons operation;
□ Hard screen acrylic material is used to protect screen.
□ Silicone panel and buttons are adopted to increase high and low temperature adaption
ability.
□ Power supply range DC (8~35)V, compatible with 12V or 24V starting batteries;
□ Generator single phase voltage, current, frequency, power and load percentage parameters
are measured and displayed:
Generator Voltage V Generator Frequency Hz
Generator Power kW Generator Current A
Load Percentage %
□ Precision measured and displayed parameters of engine:
Oil Pressure kPa Temperature ºC
Fuel Level % Total Running Time H (max. 199999 hours)
Battery Voltage V Engine Speed RPM
Accumulated Start Times (max. 199999 times, displayed on PC)
□ With genset fault protection and display functions.
□ 3 working modes: manual, auto, stop;
□ Compatible with multiple temperature, pressure, fuel level sensors, which can be
user-defined and used directly; temperature sensors, pressure sensors can be used in
parallel with annunciator, providing analog quantity and increasing protection level at the
same time;
□ Multiple crank disconnect conditions to select (engine speed sensor, oil pressure, generator
frequency);
To Next Page
Loading...
Need help?
General
