HGM6100LT Series Genset Controller User Manual Page 9 of 50
4 OPERATION
4.1 KEYS DESCRIPTION
Table 3 – Keys Description
Can stop generator under Manual/Auto mode; Can reset shutdown
alarm; Press this key at least 3 seconds to test panel indicators are OK
or not (lamp test);
During stopping process, press this key again can stop generator
immediately.
Press it will start standby genset under Manual mode; genset will jump
to next status if press this key in starting process.
Pressing this key will set the module as Manual mode.
Pressing this key will set the module as Auto mode.
Can control gens to switch on or off in Manual mode.
Note: the key is fit for HGM6120LT controller.
Can control gens to switch on in Manual mode.
Note: the key is fit for HGM6110LT controller.
Can control gens to switch off in Manual mode.
Note: the key is fit for HGM6110LT controller.
Press this key to enter menu interface;
Shift cursor to confirm in parameters setting menu.
Screen scroll;
Up cursor and increase value in setting menu.
Scroll screen;
Down cursor and decrease value in setting menu.
Return to homepage when in main interface;
Exit when in parameters setting interface.
To Next Page
Loading...
