System Log
Advanced Mode
This section explains how to congure the Network Camera to send the system log to
the remote server as backup.
Remote Log
You can congure the Network Camera to send the system log le to a remote server as a log
message.
When using this feature, the appropriate syslog server is required for receiving the system log
message from the Network Camera.
Follow the steps below to set up the remote log:
1. In the IP address text box, enter the IP address of the remote server.
2. In the port text box, enter the port number of the remote server.
3. When completed, select Enable remote log and click Save to enable the setting.
Current Log
This column displays the system's log in chronological order. The system log is stored in the
Network Camera's buer area and will be overwritten when reaching a certain amount.
The system log messages stored in the Network Camera will be all cleared after reboot or
power down the Network Camera.
View Parameters
Advanced Mode
The View Parameters page lists the entire system’s parameters in alphabetical order. If
you need technical assistance, please provide the information listed on this page.
To Next Page
Loading...