Camera Control
This section explains how to control the Network Camera’s Pan/Tilt/digitl Zoom
operation via the control panel and how to preset positions.
Preset Positions
You can preset positions for the Network Camera to go to directly or patrol. A total of 20
preset positions can be congured.
Please follow the steps below to preset a position:
1. Adjust the shooting area to the desired position using the buttons on the right side of the
window.
2. Click Set as home or Default home to dene your home position.
3. Enter a name for the preset position, which allows for up to forty characters. Click Add to
enable the settings. The preset positions will be displayed under the Preset Location list on
the left-hand side.
4. To add additional preset positions, please repeat steps 1~2.
5. To remove a preset position from the list, select it from the drop-down list and click Delete.
6. The preset positions will also displayed on the main page. Please refer to the illustration on
the next page.
7. Click Save to enable the settings.
Functions are the same as the
Control Panel on the home page
1
2
5
7
3
3
To Next Page
Loading...