When completed, click Save to enable the settings and click Close to exit Event Settings page.
The new event settings / server settings / media settings will appear in the event drop-down
list on the Application page.
Here is an example of the Application page with an event setting:
When the Event Status is ON, once an event is triggered by motion detection, the Network
Camera will automatically send snapshots via e-mail.
If you want to stop the event trigger, you can click ON to turn it to OFF status or click Delete to
remove the event setting.
To remove a server setting from the list, select a server name from the drop-down list and
click Delete. Note that only when the server setting is not being applied to an event setting can
it be deleted.
To remove a media setting from the list, select a media name from the drop-down list and
click Delete. Note that only when the media setting is not being applied to an event setting can
it be deleted.
To Next Page
Loading...