FTP: Select to send the media les to an FTP server when a trigger is activated.
■ Server address: Enter the domain name or IP address of the FTP server.
■ Server port
By default, the FTP server port is set to 21. It can also be assigned to another port number
between 1025 and 65535.
■ User name: Enter the login name of the FTP account.
■ Password: Enter the password of the FTP account.
■ FTP folder name
Enter the folder where the media le will be placed. If the folder name does not exist, the
Network Camera will create one on the FTP server.
■ Passive mode
Most firewalls do not accept new connections initiated from external requests. If the FTP
server supports passive mode, select this option to enable passive mode FTP and allow data
transmission to pass through the rewall.
To verify if the FTP settings are correctly congured, click Test. The result will be shown in a
pop-up window as shown below. If successful, you will also receive a test.txt le on the FTP
server.
Click Save to enable the settings, then click Close to exit the page.
To Next Page
Loading...