I
NSTALLATION
2-9
Note: When connecting to the WAN port, use 100-ohm Category
3, 4 or 5 shielded or unshielded twisted-pair cable with
RJ-45 connectors at both ends for all connections.
Connect a Printer
If you connect a printer to the Barricade, all the computer users
connected to your LAN can have access to this printer. Connect a
standard parallel printer cable to the Printer port on the Barricade,
and configure the printer server as described on page 6-1.
Connecting the Power Adapter
Plug the power adapter into the power socket on the Barricade,
and the other end into a power outlet. Check the indicator marked
Power on the front panel to be sure it is on. If the Power i
ndicator
does not light up, refer to
Troubleshooting in Appendix A.
To Next Page
Loading...
Need help?
General
