T
ROUBLESHOOTING
A-3
Management Problems
Cannot connect using
the Web browser
• Be sure to have configured the Barricade with a
valid IP address, subnet mask and default
gateway.
• Check that you have a valid network connection
to the Barricade and that the port you are using
has not been disabled.
• Check the network cabling between the
management station and the Barricade.
Forgot or lost the
password
• Press the Reset button on the front panel
(holding it down for at least five seconds) to
restore the factory defaults.
Printer Server
The printer cannot
print or prints garbage
• Make sure the parallel cable between the
Barricade and printer is connected and is in good
condition
Troubleshooting Chart
Symptom Action
To Next Page
Loading...
Need help?
General
