Electric Actuators
Air Cylinders
IO-Link Communication
Application
PLC
PLC
Communication protocols
EX260
<Applicable Electric Actuators>
Both air and electric systems can be established
under the same protocol.
Can be additionally installed in
an existing network
IO-Link
master
Two communication ports are provided.
∗ For the DeviceNet
®
type and CC-Link type, transition wiring is
possible using a branch connector.
∗ 1 to 1 in the case of IO-Link
Transition wiring of communication cables
Step no. defi ned operation: Operate using the preset
step data in the controller.
Numerical data defi ned operation: The actuator operates
using values such as position and speed from the PLC.
Numerical information, such as the current speed, current
position, and alarm codes, can be monitored on the PLC.
Two types of operation command
Numerical monitoring available
EtherCAT/EtherNet/IP™/PROFINET/
DeviceNet
®
/IO-Link/CC-Link Direct Input Type
Step Motor Controller/JXC Series
Fieldbus Network
p. 18
JXCE1 JXCL1 JXCLF JXCM1
With
STO
sub-
function
JXC91 JXCP1 JXCD1
Slider Type
LEF Series
Rod Type
LEY/LEYG Series
Gripper
LEH Series
Slide Table
LES/LESH Series
Slide Table/High Precision Type
LESYH Series
Rotary Table
LER Series
Miniature Type
LEPY/LEPS Series
Low Profi le Slider Type
LEM Series
Guide Rod Slider
LEL Series
High Rigidity and
High Precision Slider Type
LEKFS Series
3
Step Motor Controller JXC Series
To Next Page
Need help?
General
